How to repair a malfunction in the high-pressure molding machine?

When the high-pressure Molding Machine malfunctions, the following steps can be followed for maintenance:

1. Stop operation and power off: First, immediately stop the operation of the high-pressure molding machine and cut off the power to ensure safety.

2. Check the fault phenomenon: carefully observe the fault phenomenon of the high-pressure molding machine, such as whether there is any abnormal sound, smoke, odor, etc. Record the specific situation of the fault phenomenon for reference during subsequent repairs.

3. Check the power supply and circuit: Check if the power supply and circuit of the high-voltage molding machine are normal. Ensure that the power supply wiring is correct and check if the fuses or circuit breakers in the circuit are damaged. If necessary, damaged fuses can be replaced or circuit breakers can be reset.

4. Cleaning and lubrication: Clean the inside and outside of the high-pressure molding machine to ensure that there are no debris or dust blocking the machine. At the same time, check the lubrication system to ensure sufficient supply of lubricating oil, and replace the lubricating oil according to the prescribed cycle.

5. Check the transmission system: Check the transmission system of the high-pressure molding machine, including belts, chains, gears, etc. Ensure the normal operation of the transmission system, and promptly repair or replace any loose, worn or damaged components.

6. Check the control system: Check the control system of the high-pressure molding machine, including switches, buttons, sensors, etc. Ensure the normal operation of the control system, and if necessary, adjust or replace faulty control components.